Pumping of a hydraulic actuator of coupling. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
8.1. Manual box of gear shifting
8.2. Coupling
8.2.1. General information
8.2.2. Removal and installation of a pedal of coupling
8.2.3. Pumping of a hydraulic actuator of coupling
8.2.4. Removal and installation of the main cylinder
8.2.5. Removal and installation of the executive cylinder
8.2.6. Removal and coupling installation
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

8-2-3-prokachka-gidroprivoda-scepleniya.html

8.2.3. Pumping of a hydraulic actuator of coupling

Watch that the tank of brake liquid did not appear empty. At work with brake liquid observe precautionary measures – liquid is poisonous!


 PERFORMANCE ORDER

  1. Fill the tank with fresh brake liquid.
  1. Remove a rubber cover and connect a transparent hose to the union of pumping of coupling.
  1. Lift on one step a pin from a tube.

Do not remove a pin completely.

  1. Slowly completely squeeze out and release a pedal of coupling of 15 times with an interval 2 ÷ 3 seconds. Hold a pedal to prevent weakening of a tube on the pumping union at the annex of pressure to it.
  1. Shift a tube on 5 mm in the direction specified by an arrow and lower liquid.
  1. Return a tube to a starting position.
  2. Release a pedal of coupling and wait for 5 pages.
  3. Repeat the actions described in points from 4 to 7, while in following liquid air bubbles will not disappear.



8.2.2. Removal and installation of a pedal of coupling

8.2.4. Removal and installation of the main cylinder