Systems of electric equipment of the engine. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
7.1. Ignition and engine management systems
7.2. Charge and start systems
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







43a38297

7-sistemy-ehlektrooborudovaniya-dvigatelya.html

7. Systems of electric equipment of the engine

Specifications

Tension of the storage battery, In 12
Type (FULMEN)/capacity (And • ч) batteries
  • Engine of 1.0 l
LB1 (FCM 047 620)//47
  • Engines of 1.2 l
LB2 (FCM 055 622)//55
  • Engine of 1.4 l
LB2 (FCM 050 622)//50
Type of spark plugs//interelectrode gap, mm see. Specifications
Starter type
  • L engines 1.2 and 1.4
Mitsubishi M0T84581, with reduktsionny transfer
  • All engines
Bosch 0 001 116 009, reduktsionny transfer
Tension (In)//a current (And, no more)//turns (rpm, not less) a starter without loading
  • Mitsubishi
11.0/90///2800
  • Bosch
11.5/48///5800
Minimum diameter of a collector of a starter of Bosch, mm 33.5
Minimum length of brushes of a starter of Bosch, mm 3.5
Gap between a holder of the bearing and shaft of an anchor of a starter of Mitsubishi, mm no more than 0.2
Gap between a first line of the obgonny coupling and its restrictive ring, mm
  • Mitsubishi starter
0.3 ÷ 2.5
  • Bosch starter
0.0 ÷ 3.9
Generator type Valeo 252694
Tension developed by the generator (In)//a current (And) 12/77
Current developed by the generator (And, not less) at tension 13.5 In
  • At 1800 rpm
39
  • At 2500 rpm
30
  • At 5000 rpm
76
  • At 6000 rpm
77
Supported tension in charge system, In 14.4

List of codes of malfunctions

U1000 ECM cannot contact other control units
U1001 The period of installation of communication of ECM is exceeded
P0000 Malfunctions it is not revealed
P0011 Management of phases of inlet valves is broken
P0031 Low voltage from a heater dokatalitichesky a lambda probe
P0032 High voltage from a heater dokatalitichesky a lambda probe
P0037 Low voltage from a heater post-catalytic a lambda probe
P0038 High voltage from a heater post-catalytic a lambda probe
P0107 Low voltage from the MAP sensor
P0108 High voltage from the MAP sensor
P0112 Low voltage from the IAT sensor
P0113 High voltage from the IAT sensor
P0117 Low voltage from the ECT sensor
P0118 High voltage from the ECT sensor
P0132 Low voltage from dokatalitichesky a lambda probe
P0133 Too long recognition of a signal from dokatalitichesky a lambda probe
P0134 Dokatalitichesky a lambda probe it is not active
P0138 High voltage from post-catalytic a lambda probe
P0139 Too long recognition of a signal from post-catalytic a lambda probe
P0171 The regrown poor working mix
P0172 The reenriched working mix
P0221 Malfunction in a chain of the sensor of provision of a butterfly valve (TPS)
P0222 Low voltage from the TPS 1 sensor
P0223 High voltage from the TPS 1 sensor
P0226 Malfunction in an APP sensor chain
P0227 Low voltage from the APP 1 sensor
P0228 High voltage from the APP 1 sensor
P0300 Ignition admissions in several cylinders
P0301 — P0304 Ignition admissions in cylinders No. 1-№4 respectively
P0327 Low voltage from the detonation sensor
P0328 High voltage from the detonation sensor
P0335 Malfunction in a CKP sensor chain
P0340 Malfunction in a CMP sensor chain
P0420 Efficiency of the catalytic converter is lower than admissible level
P0444 Gap in a chain Ý/m the valve of management of a purge of an absorber of EVAP
P0500 ECM does not receive a correct signal from the sensor of speed of the car (VSS)
P0605 ECM is faulty
P0705 Malfunction in a PNP sensor chain
P0710 Too low or high voltage from the sensor of temperature of ATF
P0720 TCM does not receive a correct signal from the VSS sensor
P0725 TCM does not receive a correct signal from ECM
P0731 — P0734 AT cannot be switched to 1-4 transfer respectively, despite serviceability of an electric chain
P0740 TCM finds power failure in influence attempt on Ý/m the valve of the coupling of the hydrotransformer
P0745 TCM finds power failure in influence attempt on Ý/m the pressure valve in lines
P0750/P0755 TCM finds power failure in influence attempt on Ý/m the switching valve according to A or B
P1065 Malfunction in ECM power-supply circuit
P1111 Malfunction in a chain Ý/m the valve of management of adjustment of phases of inlet valves
P1121 The butterfly valve activator is faulty
P1122 Malfunction in a chain of the activator of a butterfly valve
P1124 Short circuit in a chain of the relay of the activator of a butterfly valve
P1126 Malfunction in a chain of the relay of the activator of a butterfly valve
P1128 Short circuit in a chain of the activator of a butterfly valve
P1143 The maximum and minimum values of target tension dokatalitichesky a lambda probe do not reach the established limits
P1144 The maximum and minimum values of target tension dokatalitichesky a lambda probe exceed the established limits
P1146/P1147 The maximum/minimum value of target tension post-catalytic the lambda probe does not reach the established limit
P1171 Mistake in a power supply system: excessively high target voltage from the MAP sensor
P1217 Engine overheat
P1223 Low voltage from the TPS 2 sensor
P1224 High voltage from the TPS 2 sensor
P1225 Error of definition of a closed position of a butterfly valve (value too low)
P1226 The closed position of a butterfly valve is not programmed
P1227 Low voltage from the APP 2 sensor
P1228 High voltage from the APP 2 sensor
P1229 Short circuit in a TPS sensor chain
P1610 — P1615 Malfunction of NATS system
P1705 TCM receives an incorrect signal from the APP sensor
P1706 The signal from the PNP sensor does not change at start of the engine and car movement
P1760 TCM finds power failure in influence attempt on Ý/m the valve of the obgonny coupling
P1805 The signal from the sensor of stoplights does not move on ECM during too long time at car movement

Efforts of a tightening of carving connections, N • m

Spark plugs 19.6 ÷ 29.4
Nuts of fastening of plugs on the storage battery 3 ÷ 5
Bolt of the holder of the storage battery 12.7 ÷ 15.7
Nut of the plug "B" of the generator 9.3 ÷ 10.8
Bolt of connection of weight of the generator 2.9 ÷ 4.9
Bolts of fastening of the generator 33.3 ÷ 46.1
Bolts of fastening of the top arm of the generator 33.3 ÷ 46.1
Bolts of fastening of a rack of the right support of the engine 40 ÷ 50
Bolt of fastening of an arm of an intermediate roller of a belt of a drive of the generator 16.6 ÷ 23.5
Nut of an intermediate roller of a belt of a drive of the generator 25.5 ÷ 33.3
Coupling bolt of a starter of Mitsubishi 4.1 ÷ 7.1



6.2.2. Removal and installation of components of system of release of OG

7.1. Ignition and engine management systems