Removal and generator installation. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
7.1. Ignition and engine management systems
7.2. Charge and start systems
7.2.1. General information
7.2.2. The storage battery - the general information, recommendations about service
7.2.3. Charge system – general information and security measures
7.2.4. Removal and installation of the storage battery and its holder
7.2.5. Removal and generator installation
7.2.6. System of start of the engine – the general information and precautionary measures
7.2.7. Removal and starter installation
7.2.8. Dismantling, check and starter assembly
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

7-2-5-snyatie-i-ustanovka-generatora.html

7.2.5. Removal and generator installation

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the storage battery.
  2. Remove a loker of the right forward wheel arch (see. Head Body).
  3. Remove a belt of a drive of the generator (see. Section Replacement of belts of a drive of auxiliary units and intermediate rollers of belts).
  1. Turn out bolts of fastening of an arm of an intermediate roller and remove roller assembly.
  1. Separate the socket of electroconducting of the generator. Give a plug "B" nut, a nut of a wire of weight and remove holders of electroconducting.
  1. Remove a rack of a support of the engine on the right side.
  1. Turn out a bolt of fastening of the top arm of the generator, and also the top bolt of fastening of the generator.
  1. Turn out the bottom bolt of fastening of the generator and take a bolt from an U-shaped groove. On a forward cover of the generator.
  1. Remove the generator from the car.
  2. Installation is made upside-down. Observe efforts of a tightening of fixture, after installation check and if necessary adjust a tension of a belt of a drive of the generator (see. Section Check of a condition of a belt of a drive of auxiliary units and adjustment of its tension).



7.2.4. Removal and installation of the storage battery and its holder

7.2.6. System of start of the engine – the general information and precautionary measures