Removal and installation of the steering mechanism. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.4. Steering
12.4.1. Removal and installation of a steering wheel, block of a safety cushion and spiral spring
12.4.2. Removal and installation of a steering column
12.4.3. Removal and installation of the steering mechanism
12.4.4. The amplifier of a steering - the general information
12.4.5. Corners of installation of wheels of the car - the general information
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

12-4-3-snyatie-i-ustanovka-rulevogo-mekhanizma.html

12.4.3. Removal and installation of the steering mechanism

Fixture of assembly of the steering mechanism


 PERFORMANCE ORDER

  1. Remove forward wheels and block a steering column.
  2. Turn out a bolt and disconnect an intermediate shaft from the steering mechanism.
  1. Disconnect from a rotary fist a tip of steering draft. If necessary use the special adaptation.

After removal screw on a tip carving a fixing nut not to damage a carving.

  1. Remove forward section of a pipe of system of release of OG.
  2. Give fixture of assembly of the steering mechanism and remove it through the right wheel arch.
  3. If necessary repair the steering mechanism. At its dismantling be guided by an illustration the Steering mechanism with drafts.
  1. After removal of steering drafts establish them so that the distance from a lock-nut to a boot made 62.6 mm. Check corners of installation of wheels.
  1. Installation is made upside-down.



12.4.2. Removal and installation of a steering column

12.4.4. The amplifier of a steering - the general information