Removal and installation of a steering wheel, block of a safety cushion and spiral spring. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.4. Steering
12.4.1. Removal and installation of a steering wheel, block of a safety cushion and spiral spring
12.4.2. Removal and installation of a steering column
12.4.3. Removal and installation of the steering mechanism
12.4.4. The amplifier of a steering - the general information
12.4.5. Corners of installation of wheels of the car - the general information
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

12-4-1-snyatie-i-ustanovka-rulevogo-kolesa-bloka-podushki-bezopasnosti.html

12.4.1. Removal and installation of a steering wheel, block of a safety cushion and spiral spring

Removal and installation of a steering wheel, block of a safety cushion and spiral spring

 PERFORMANCE ORDER

  1. Disconnect from the storage battery at first negative, and then a positive wire. Isolate poles of the battery and wait not less than 3 minutes.
  2. Remove lateral caps and turn out the bolts which were under them.
1 — the safety cushion Block
2, 4 — Caps
3 — the Steering wheel


Bolts can be thrown out, since their reuse is not admissible.


  1. Separate the socket of additional electroconducting of a steering wheel and electroconducting of the block of a safety cushion.
  1. Remove the block of a safety cushion and lay it an obverse surface up.

Dismantling of the block of a safety cushion is not admissible.

Do not subject the safety cushion block to temperature influence from above the 90th hail., do not allow hit in it of oils, greasings or water. If the block of a safety cushion underwent blow (for example if it dropped) replace it.


  1. Establish a steering wheel in the provision of rectilinear movement and separate sockets of a horn and a spiral spring.
  1. Turn out a bolt of fastening of a steering wheel and remove it by means of the special adaptation.
  1. In need of removal of a spiral spring remove casings of a steering column (see. Head the Body and an illustration Components of installation of a spiral spring) and podrulevy switches (see. Head Onboard electric equipment). Then turn out 2 screws and, wringing out a plastic uvula of a clamp, remove a spiral spring.
  1. Disconnect from a spiral spring sockets of electroconducting of a horn and a spiral spring.
  1. Installation is made upside-down. In summary carry out SRS system diagnostics.

Components of installation of a spiral spring

1/6 — Left/right podrulevy the switch
2/7 — the Top/bottom casing of a steering column
3 — the Spiral spring

4 — the Steering wheel
5 — the Socket of the block of a safety cushion
8 — a keyhole Fringing



12.4. Steering

12.4.2. Removal and installation of a steering column