Forward suspension bracket. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.2.1. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.2.2. Removal and installation of the cross-section lever of a suspension bracket
12.2.3. Removal and installation of the stabilizer of cross-section stability
12.2.4. Removal and stretcher installation
12.3. Back suspension bracket
12.4. Steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

12-2-perednyaya-podveska.html

12.2. Forward suspension bracket

Removal and installation, dismantling and assembly of a rack of a suspension bracket

Removal and installation

Components of installation and assembly of a rack of a forward suspension bracket are specified illustrations the Forward suspension bracket.

 PERFORMANCE ORDER

  1. Remove the corresponding wheel.
  2. Remove a windscreen fairing.
  3. Remove from a rack electroconducting of the wheel ABS sensor (see. Head Brake system) and lock plate of a brake hose.
  4. Remove a rack of the stabilizer of a suspension bracket.
  5. Give nuts and bolts of fastening of a rotary fist to a suspension bracket rack.
  6. Turn out the top bolts of fastening of a rack of a suspension bracket and remove it from the car.
  1. Installation is made upside-down. The label on the top part of a rack should be turned forward.

Dismantling and assembly

 PERFORMANCE ORDER

  1. Fix the removed rack of a suspension bracket in a vice, and establish on it the adaptation for spring compression.
  1. Slightly give a lock-nut, compress a spring and only then finally give a lock-nut.

Do not give a lock-nut completely while the spring will not be fixed in the compressed condition.

  1. Remove from a rack a spring saddle, the bearing, a spring and a boot.
  2. Check a condition of the shock-absorber and the removed components, if necessary replace them.
  3. If spring replacement is required, accurately release compressing adaptation and establish it on a new spring.
  1. Establish a spring on a rack so that the bottom round rested against the corresponding ledge.
  1. Establish a boot, the bearing and the top saddle of a spring. Make sure of correctness of installation of the top saddle of a spring.
  1. By hand tighten a lock-nut, remove the adaptation for removal of a spring and tighten a lock-nut with effort of 60 ÷ 75 N • m.



12.1. General information, recommendations and security measures

12.2.1. Removal and installation, dismantling and assembly of a rack of a suspension bracket