Removal and installation of the stabilizer of cross-section stability. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.2.1. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.2.2. Removal and installation of the cross-section lever of a suspension bracket
12.2.3. Removal and installation of the stabilizer of cross-section stability
12.2.4. Removal and stretcher installation
12.3. Back suspension bracket
12.4. Steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

12-2-3-snyatie-i-ustanovka-stabilizatora-poperechnojj-ustojjchivosti.html

12.2.3. Removal and installation of the stabilizer of cross-section stability

Components of installation of the stabilizer of a suspension bracket are specified illustrations the Forward suspension bracket.


 PERFORMANCE ORDER

  1. Remove forward wheels.
  2. Give a nut and disconnect from the stabilizer its rack.
  3. Disconnect from a rotary fist a tip of steering draft. If necessary use a stripper.

After removal screw a nut on a tip carving not to damage it.


  1. Remove a support of a pipe of system of release of OG.
  1. Remove the pendular lever (a back support) engine (see. Section Removal and installation of the power unit).
  2. Turn out back bolts of a rack of a stretcher.
  3. Prop up a stretcher a jack and turn out boats of fastening of a stretcher and a stretcher rack.
  4. Lower a stretcher so that it was possible to turn out bolts of fastening of the stabilizer.
  5. Turn out bolts and remove collars of fastening of the stabilizer. Remove the stabilizer.

Bolts of collars of the stabilizer of models with AT

Bolts of collars of the stabilizer of models with RKPP
 
  1. Check on existence of damages the stabilizer and its plugs. If necessary replace them.
  1. Installation is made upside-down. On an illustration - correct (at the left) and not correct (on the right) the provision of installation of a rack of the stabilizer

Pillow of a rack of the stabilizer it is necessary to have parallel to the stabilizer.




12.2.2. Removal and installation of the cross-section lever of a suspension bracket

12.2.4. Removal and stretcher installation