Removal and installation of the cross-section lever of a suspension bracket. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.2.1. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.2.2. Removal and installation of the cross-section lever of a suspension bracket
12.2.3. Removal and installation of the stabilizer of cross-section stability
12.2.4. Removal and stretcher installation
12.3. Back suspension bracket
12.4. Steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

12-2-2-snyatie-i-ustanovka-poperechnogo-rychaga-podveski.html

12.2.2. Removal and installation of the cross-section lever of a suspension bracket

Components of installation of the cross-section lever of a suspension bracket are specified illustrations the Forward suspension bracket.


 PERFORMANCE ORDER

  1. Remove the corresponding wheel.
  2. Give nuts and bolts of a spherical support of a suspension bracket and disconnect the cross-section lever from a rotary fist.
  3. Give nuts and bolts of fastening of the cross-section lever to a stretcher and remove the lever.

At removal of the left lever on models from AT for an otdavaniye of bolts lower a stretcher. For this purpose previously prop up a stretcher a jack, give a bolt of fastening of the right top draft, a bolt of fastening of the left top draft (from a stretcher), and also bolts of fastening of a stretcher.

  1. Check removal components and if necessary replace them.
  2. Installation is made upside-down. After installation check corners of installation of wheels.



12.2.1. Removal and installation, dismantling and assembly of a rack of a suspension bracket

12.2.3. Removal and installation of the stabilizer of cross-section stability