Removal and installation of assembly of back brake mechanisms. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
11.1. General information and security measures
11.2. Removal and installation of brake lines
11.3. Removal and installation of a pedal of a brake
11.4. Removal and GTTs installation
11.5. Removal and installation of the vacuum amplifier
11.6. Replacement of brake shoes of forward wheels
11.7. Removal and installation of forward brake mechanisms and brake disks
11.8. Removal and installation of assembly of back brake mechanisms
11.9. Removal and installation of a drive of the parking brake
11.10. Removal and installation of components of ABS system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

11-8-snyatie-i-ustanovka-sborki-zadnikh-tormoznykh-mekhanizmov.html

11.8. Removal and installation of assembly of back brake mechanisms

Removal

Components of assembly of the back brake mechanism

1 — the Drum
2/3 — the Bottom/top coupling spring
4 — Razzhimnaya a level
5 — the Clamp
6 — the Block
7 — the Wheel cylinder
8 — the pumping Union

9 — the Protective cap
10 — the Piston
11 — the Basic cup
12 — the Spring
13 — the Brake board
14 — Directing blocks

 PERFORMANCE ORDER

  1. To Poddomkratta the car also remove the corresponding wheel.
  2. At the released parking brake remove a brake drum (see. Section Removal and installation of stupichny assembly of a back wheel).
  1. At the same time wringing out and rotating clamps, extend directing blocks and remove assembly of blocks.

Do not damage thus protective caps of the wheel cylinder.

  1. Disconnect a cable of the parking brake.
  2. If necessary disconnect from blocks coupling springs and a razzhimny level.
  3. For removal of the wheel cylinder disconnect from it a brake tube and turn out its fixing bolts.

Installation

 PERFORMANCE ORDER

  1. If acted in film, establish the wheel cylinder.
  1. Put Nissan KRF0000005 greasing on sliding surfaces of brake boots and on the surfaces of a brake board specified illustrations.
  1. Truncate a razzhimny level, rotating its tip.

The Razzhimny level on the left/right side of the car has respectively the left/right carving.

  1. Connect to blocks a razzhimny level and coupling springs. Connect a cable of the parking brake.
  2. Establish assembly of blocks, trying not to damage thus protective caps of the wheel cylinder, and make sure that correctness of installation of components.
  3. Establish a brake drum (see. Section Removal and installation of stupichny assembly of a back wheel).
  4. Adjust the parking brake. If the wheel cylinder acted in film, pump over brake system (see. Section Replacement of brake liquid and pumping of brake system).



11.7. Removal and installation of forward brake mechanisms and brake disks

11.9. Removal and installation of a drive of the parking brake