Replacement of brake shoes of forward wheels. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
11.1. General information and security measures
11.2. Removal and installation of brake lines
11.3. Removal and installation of a pedal of a brake
11.4. Removal and GTTs installation
11.5. Removal and installation of the vacuum amplifier
11.6. Replacement of brake shoes of forward wheels
11.7. Removal and installation of forward brake mechanisms and brake disks
11.8. Removal and installation of assembly of back brake mechanisms
11.9. Removal and installation of a drive of the parking brake
11.10. Removal and installation of components of ABS system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

11-6-zamena-tormoznykh-kolodok-perednikh-koles.html

11.6. Replacement of brake shoes of forward wheels

Replacement of blocks should be made at the same time on both wheels of one axis (i.e. 4 blocks).

Components of the forward brake mechanism

1 — the Anchor bracket
2 — the Directing finger
3 — the Boot
4/5 — Top/bottom holders of blocks
6/7 — the Internal/external block
8 — the Support

9 — the Sealing ring
10 — the Piston
11 — the Protective cap
12 — the Hollow bolt
13 — Copper washers
14 — the pumping Union

 PERFORMANCE ORDER

  1. To Poddomkratta the car also remove the corresponding wheel.
  2. Uncover the tank of brake liquid.
  1. Turn out the bottom bolt of fastening of a support.
  1. Lift a support and tie up it to body elements, without straining a brake hose.
  2. Remove from an anchor bracket old brake shoes and their holders. Put on a back surface of new blocks and on an interfaced surface of holders PBC greasing or silicone containing greasing.
  3. Establish blocks and their holders.
  4. Lower a support. If new blocks are established, slightly wring out the piston, at the same time watching that brake liquid did not pour out from the tank.
  5. After installation before a trip several times squeeze out a brake pedal that blocks occupied working situation.



11.5. Removal and installation of the vacuum amplifier

11.7. Removal and installation of forward brake mechanisms and brake disks