Removal and installation of the vacuum amplifier. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
11.1. General information and security measures
11.2. Removal and installation of brake lines
11.3. Removal and installation of a pedal of a brake
11.4. Removal and GTTs installation
11.5. Removal and installation of the vacuum amplifier
11.6. Replacement of brake shoes of forward wheels
11.7. Removal and installation of forward brake mechanisms and brake disks
11.8. Removal and installation of assembly of back brake mechanisms
11.9. Removal and installation of a drive of the parking brake
11.10. Removal and installation of components of ABS system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

11-5-snyatie-i-ustanovka-vakuumnogo-usilitelya.html

11.5. Removal and installation of the vacuum amplifier

Components of fastening of the vacuum amplifier


 PERFORMANCE ORDER

  1. Disconnect from the vacuum amplifier a vacuum hose.
  2. Remove GTTs (see. Section Removal and GTTs installation).
  3. Take шплинт and an axial pin of a pedal of a brake (see. Section Removal and installation of a pedal of a brake).
  4. Give nuts of fastening of the vacuum amplifier and assembly of a pedal of a brake.
  5. Remove the main cylinder of coupling from the panel, extend it from an impellent compartment and place so that it did not disturb work.
  1. Holding an arm, remove a hose of the lowered pressure of К/В system.
  1. Remove a windscreen fairing (see. Head Body) and vacuum amplifier.
  1. Check the size (B) of a ledge of a rod of the vacuum amplifier and compare it to requirements of Specifications. If necessary replace or repair the vacuum amplifier.
  1. Installation is made upside-down.



11.4. Removal and GTTs installation

11.6. Replacement of brake shoes of forward wheels