Removal and GTTs installation. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
11.1. General information and security measures
11.2. Removal and installation of brake lines
11.3. Removal and installation of a pedal of a brake
11.4. Removal and GTTs installation
11.5. Removal and installation of the vacuum amplifier
11.6. Replacement of brake shoes of forward wheels
11.7. Removal and installation of forward brake mechanisms and brake disks
11.8. Removal and installation of assembly of back brake mechanisms
11.9. Removal and installation of a drive of the parking brake
11.10. Removal and installation of components of ABS system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

11-4-snyatie-i-ustanovka-gtc.html

11.4. Removal and GTTs installation

Components of assembly of GTTs

1 — the Lock cap
2 — Assembly of the primary piston
3 — the Socket of the sensor of level of brake liquid
4 — a coupling Hose (models with RKPP)
5 — the Tank of brake liquid

6 — Assembly of the secondary piston
7 — Laying
8 — the Screw
9 — the piston Limiter
10 — a tank Cover

 PERFORMANCE ORDER

  1. Lower brake liquid (see. Section Replacement of brake liquid and pumping of brake system).
  2. Separate the socket of electroconducting of the sensor of level of brake liquid.
  1. On models from RKPP remove a coupling hose.
  1. By means of a cap key disconnect from GTTs assembly brake tubes.
  2. Give nuts of fastening of assembly of GTTs and remove it from the vacuum amplifier.
  3. If necessary make the repair connected with dismantling and assembly of GTTs.
  4. Fix by hand brake tubes on GTTs.
  5. Establish GTTs assembly on the vacuum amplifier and tighten GTTs fixture with effort of 14 N • m.
  6. Tighten brake tubes with effort of 16 N • m.
  7. On models from RKPP establish a coupling hose.
  8. Fill and pump over brake system (see. Section Replacement of brake liquid and pumping of brake system). On models from RKPP pump over coupling.



11.3. Removal and installation of a pedal of a brake

11.5. Removal and installation of the vacuum amplifier