Removal and installation of components of ABS system. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
11. Brake system
11.1. General information and security measures
11.2. Removal and installation of brake lines
11.3. Removal and installation of a pedal of a brake
11.4. Removal and GTTs installation
11.5. Removal and installation of the vacuum amplifier
11.6. Replacement of brake shoes of forward wheels
11.7. Removal and installation of forward brake mechanisms and brake disks
11.8. Removal and installation of assembly of back brake mechanisms
11.9. Removal and installation of a drive of the parking brake
11.10. Removal and installation of components of ABS system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

11-10-snyatie-i-ustanovka-komponentov-sistemy-abs.html

11.10. Removal and installation of components of ABS system

The arrangement of the ABS components is specified illustrations the Arrangement of components of auxiliary systems.

Components of installation of the activator and ABS control unit


 PERFORMANCE ORDER

  1. At removal of wheel sensors do not rotate them and do not pull strongly for their electroconducting.
  2. Rotors of forward wheel sensors are combined with stupichny bearings and are replaced as uniform knot (see. Head Power shafts, rotary fists and stupichny assemblies).
  3. For removal of rotors of back wheel sensors it is required to remove a brake drum (see. Section Removal and installation of stupichny assembly of a back wheel).

Removals a rotor of the back wheel sensor to reuse it is not allowed.

  1. Before removal of the activator and the ABS control unit disconnect a negative wire from the storage battery. At installation press on the activator that it was fixed on an arm. After installation pump over brake system (see. Section Replacement of brake liquid and pumping of brake system).



11.9. Removal and installation of a drive of the parking brake

12. Suspension bracket and steering