Removal and installation of a rotary fist. Nissan Micra (since 2002 of release)
Service and to Nissan Micra car repairs (since 2002 of release)
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Power shafts, rotary fists and stupichny assemblies
10.1. General information
10.2. Removal and installation of a rotary fist
10.3. Replacement of boots of power shafts
10.4. Removal and installation of power shafts
10.5. Dismantling and assembly of power shafts
10.6. Removal and installation of stupichny assembly of a back wheel
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes
 







f4fb234a

10-2-snyatie-i-ustanovka-povorotnogo-kulaka.html

10.2. Removal and installation of a rotary fist

Assembly of a rotary fist

1 — the Rotary fist
2 — the Casing of the wheel sensor
3 — Stupichny the bearing

4 — the Lock ring
5 — the Nave
6 — the Power shaft

 PERFORMANCE ORDER

  1. To Poddomkratta the car also establish it on props. Remove the corresponding wheel.
  2. Remove from a rack of a forward suspension bracket a lock plate and disconnect from a rack a brake hose (see. Head Brake system).
  3. Remove from a rotary fist a support of the brake mechanism and fix it aside that it did not disturb work (see. Head Brake system).

Thus do not allow, that the brake hose was loaded. Do not press a brake pedal at the removed support that the piston did not leave the brake cylinder.

  1. Remove from a nave a brake disk (see. Head Brake system).
  2. Extend from a rotary fist the wheel ABS sensor (see. Head Brake system).

Do not pull for sensor electroconducting.

  1. Holding a nave from a provorachivaniye, give a stupichny nut.
  1. Having used a special stripper, disconnect from a rotary fist a tip of steering draft. Temporarily screw a nut on a tip carving
  2. Remove a rotary fist from a suspension bracket rack.

Do not allow a deviation of a power shaft on a corner more the 22nd hail.

  1. Separate from a rotary fist a power shaft and tie up it that it did not fall.

Do not allow a deviation of a power shaft on a corner more the 22nd hail.

  1. Give a bolt and a nut of a spherical support of a suspension bracket and disconnect the suspension bracket lever from a rotary fist.
  2. If necessary replace the stupichny bearing.
  3. Installation is made upside-down. Tighten fixture with demanded efforts and in demanded sequence – see the corresponding chapters.



10.1. General information

10.3. Replacement of boots of power shafts